Wood Ballet Barres
For Wall Mounted or Floor Mounted Ballet Barres
Choose from Unfinished Hard Maple Ballet Barre, Unfinished Red Oak Ballet Barre, or Unfinished Ash Ballet Barre
This wall mounted or floor mounted ballet barre material is made from America's finest wood selection:
• 1 5/8" Diameter Unfinished Ash Wood Barre(good)
• 1 5/8" Diameter Unfinished Red Oak Wood Barre(better)
• 1 5/8" Diameter Unfinished Hard Maple Wood Barre (best - strongest)
• 2" Diameter Unfinished Red Oak Barre
• 2" Diameter Unfinished Hard Maple Barre
All Barres come well sanded, finish ready and beveled on both ends, unless instructed otherwise.
Barres longer than 8' will be pre-drilled for connection (to connect wood sections) and beveled on the ends.
Wood finishes are available only on our Barre Kits. (when you buy Barre and Brackets as a kit)
BRACKETS ARE NOT INCLUDED!
Quality is our #1 priority!
All orders are custom made-to-order and processed in the order of receipt. Production time for is normally 7-10 business days (excluding weekends and holidays) plus ground shipping (varies by your location).
Large orders may require additional production time. Wood finishes require 10-14 business days.
If your order is ready sooner we always ship immediately!
Note - Production and Shipping times are estimated and not guaranteed.
Please be advised that Custom Barres wood diameter's acceptance tolerance is +/- 1/32. If you did not purchase the brackets from Custom Barres we cannot guarantee that your wood will fit in your brackets. Please make sure your bracket's ID allows some wiggle room. We highly suggest purchasing the brackets from Custom Barres to ensure a perfect fit.
Q. SHOULD I USE 1 5/8" DIAMETER OR 2" DIAMETER BARRE?
A. The 1 5/8” Diameter is our standard size and is most commonly used in Dance Studios and Fitness Centers. The grip is significantly smaller than the 2" diameter and therefore is much easier for your hand to wrap around and hold the barre.
It is ultimately a personal preference, as both size barres will work well; however, most ballet and barre fitness installations will typically use the 1 5/8" barre, as it has sufficient strength, smaller grip and is more economical.
The 2" diameter barre is beautiful, very strong and makes a statement. It is usually used for Fusion Classes where there are a lot of exercises underneath the barre, pushing the legs onto the barre.
IMPORTANT: Please don't forget to purchase your brackets and make sure to choose the correct diameter for your brackets!!!
If you are connecting the wood bars, we highly suggest choosing the option to pre-drill connecting bars so you have a strong connection between two sections. We will pre-drill the center of the barres for connection and provide you with the necessary hardware. Your installer will use a high quality wood glue (not provided) to connect the joining barres.
Custom Barres will do this service complimentary, FREE of charge!